Lay out your stock (we are using 3/4" poplar here) to determine where you want your joints to go. Clamp the jig at the end of the stock, centered.
| how to: The Kreg Jig | for a quick, simple, strong joint, the Kreg Jig can't be beat. Line up your stock, drill a few pilot holes, add some glue, drive the screws, done! Read the details here... |
| Lay out your stock Lay out your stock (we are using 3/4" poplar here) to determine where you want your joints to go. Clamp the jig at the end of the stock, centered. |
|
 |
Drill the holes Now drill two holes through the jig using the drill bit. This bit can be adjusted for thicker stock. Clean off the sawdust and remove the jig. |
| Drive the screws Now drive the special screws using the long square head drill bit. Add some glue onto the joint for added strength. The screws pull the joint together tightly. Your done! |
 |
| Buy this right now: The jig comes with the adjustable drill bit, the long square head driver, the adjustable clamp and an extension part for working with wood thicker than 3/4". The kit also comes with some starter screws, but purchase more. The screws are special square head with washer heads to help hold them in place. |
 |
|